Table of Contents
Advertisement
Enroll Sensors and Devices
To Enroll Sensors (Zones) and Peripheral Devices:
1. On the "Panel Settings" page, select "Add Device".
Devices can be enrolled in two ways, either through Auto Enrollment or by entering the serial number of the device
into the "Add Device by Serial Number" form.
To add by serial number,
l
a. Select the "Add Device" tool and enter the serial number of the device in the serial number field.
Once a valid serial number has been entered, additional options specific to the device are displayed.
b. Rename the Zone by entering the desired zone name into the "Label" field.
c. Select additional zone or device options as required.
d. Once all options are selected, "Submit" the form.
To add by Auto Enrollment,
l
a. Select the "Add Device" tool and turn the Auto Enroll option ON.
b. Once Device Auto Enroll is ON, press and hold the device enroll button until the LED lights steady and
then release while the LED is still lit.
c. Continue enrolling zones and peripheral devices until all devices have been enrolled.
Devices are enrolled directly under the respective panel settings sub-sections (zones, wireless keys, wire-free
keypads, sirens).
2. Navigate to each sub-section to customize the device/zone names and options as required.
To wall-mount the Panel:
1. Select a permanent location near a power outlet. The wall should be flat and free from vibration and shock.
2. If cables are to be surface run, remove the two breakaway tabs from the bottom of the mounting plate. Otherwise,
pass the Ethernet and AC cables through the opening in the back of the mounting plate.
1.
Mounting Location
2.
Orientation Guide
3.
Tamper Bracket
4.
Cable Opening
5.
Breakaway Tabs
Figure 2-2 Mounting Bracket
3. Position the mounting plate on the wall then mark the 4 screw locations.
4. Fasten the mounting plate to the wall using the supplied hardware.
5. If necessary, remove the battery access cover on the back of the iotega and insert the battery. See Battery Replace-
ment for details.
6. Connect the Ethernet cable and AC adapter to the ports on the back of the panel.
7. Insert the bottom of the iotega into the mounting bracket, then press the top in until it clicks into place. If surface-run-
ning the cables, ensure they are channeled through the knock-out openings on the mounting plate.
Battery Replacement
Note: When replacing the battery, use battery pack suitable for the application. Refer to on page 4.
To remove the battery:
Section 2: Installation
2
3
1
5
4
- 8 -
1
Advertisement
Table of Contents
