DSC iotega WS910 Reference Manual page 40

Device Partition Assignment
This option is used to assign the wireless device to an avail-
able partition.
Default:
Valid range:
Chime Tone
This option is used to select the tone emitted by the device
when the zone is tripped.
Default: Beeps
Valid range: Beeps, Bing Bing, Ding Dong, Alarm Tone
Device Label
This section is used to program a custom label for the
device.
Default: Zone ZZZ
Valid range: 32 character ASCII
Zone Type
This programming section is used to program a zone type
for the device.
Default: Interior Follower
Valid Instant, Interior Follower, Interior Stay/Away, Delay Stay/Away, 24
range: Hour Supervisory Buzzer, 24 Hour Non Alarm
Zone Attribute
This section is used to customize zone behavior for the
device. The table below specifies the status of each attribute
for this device.
See "Available Zone Attributes" on page 43 for attribute
definitions.
Door Chime
Alarm Report
Burglary Verified
Transmission Delay
Bell Audible
Bell Steady
Bypass Enable
Force Arm
Swinger Shutdown
Two Way Audio
Talk Listen
Supervision
This section is used to enable/disable wireless supervision
of the device. Supervision monitors the presence of the wire-
less device on the alarm system.
Default: Enabled
Valid range: Enabled/Disabled
Alarm LED
This option is used to enable/disable the device's onboard
LED. When enabled, the LED activates when an alarm
Section 4: Programming Options
1
1-4
Disabled
Enabled
Enabled
Enabled
Enabled (read-only)
Enabled (read-only)
Enabled (read-only)
Disabled (read-only)
Enabled (read-only)
Enabled (read-only)
Enabled (read-only)
occurs.
Default:
Valid range:
High Traffic Shutdown
Activating this feature helps conserve battery power when
the system is disarmed by configuring a reporting timer.
When motion is detected, the device transmits an alarm to
the receiver and does not report any further events until the
timer expires. Any motion detected during the configured
period is reported once the timer expires. No Delay causes
the device to report an alarm each time the detector is
tripped.
Default: Not Active
Valid Not Active, No Delay, 5 Second Delay, 15 Second Delay, 30 Second
range: Delay, 1 Minute Delay, 5 Minute Delay, 10 Minute Delay, 20 Minute
Delay, 60 Minute Delay
Event Counter
This option is used to set the number of alarm events
required to activate the alarm.
Default:
Valid range:
Image Brightness
This option is used to lighten or darken the camera image.
Default:
Valid range:
Image Contrast
This option is used to lighten or darken the contrast of the
camera image.
Default:
Valid range:
Color
When this option is enabled, the camera captures color
images. When disabled, the camera captures black and
white images.
Default:
Valid range:
High Resolution
When this option is enabled, the camera captures high res-
olution images (320 x 240 dpi). When disabled, image res-
olution is 160 x 128 dpi.
Default:
Valid range:
Normal Quality
When this option is enabled, the camera captures lower res-
olution images (160 x 128 dpi).
- 37 -
Enabled
Enabled/Disabled
Low
Low/High
0
-3, -2, -1, 0, 1, 2, 3
o
-3, -2, -1, 0, 1, 2, 3
Enabled
Enabled/Disabled
Enabled
Enabled/Disabled