Controls And Indicators - DSC iotega WS910 Reference Manual

1. Detach the iotega from the mounting plate by inserting a flat blade screwdriver into the slots on top of the plate and
gently prying.
Disconnect the AC and Ethernet cables from the iotega.
2. Remove the access cover from the back of the panel.
3. Push the battery retention tab in the direction of the arrow in Figure 2-3 .
4. Lift the battery from the front, then pull up and slide out.
Push tab
release
Figure 2-3 Battery Removal
To Install a new battery:
1. Insert the battery, back end first.
2. Press the front of the battery down until the retention tab clicks into place.
3. Replace the back cover of the panel.

2.2 Controls and Indicators

The iotega provides a series of LED indicators to notify users of system status.
Figure 2-4 LED Indicators
1 2 3 4
Table 2-1 LED Indicator Operation
Section 2: Installation
to
7
5 6 8 9
1. Microphone
2. Siren
3. Remote Connection LED
4. Cellular Signal Strength LED
5. WiFi Signal Strength LED
6. Trouble LED
7. Armed LED
8. Ready to Arm LED
9. Power LED
- 9 -