DSC iotega WS910 Reference Manual page 4

Safety Instructions for Skilled Persons
Warning: When using equipment connected to the telephone network, always follow
the basic safety instructions provided with this product. Save these instructions for
future reference. Inform the end-user of the safety precautions that must be observed
when operating this equipment.
Before Installing The Equipment
Ensure your package includes the following items:
Installation and User manuals, including the SAFETY INSTRUCTIONS.
l
READ and SAVE these instructions!
Follow all WARNINGS AND INSTRUCTIONS specified within this doc-
ument and/or on the equipment.
iotega alarm controller with mounting plate
l
Ethernet cable
l
Mounting hardware
l
Selecting A Suitable Location For The Alarm Controller
Use the following list as a guide to find a suitable location to install this equipment:
Locate near a power outlet.
l
Select a location free from vibration and shock.
l
Place alarm controller on a flat, stable surface and follow the installation
l
instructions.
Do NOT locate this product where people may walk on the secondary circuit cable(s).
Do NOT connect alarm controller to electrical the same circuit as large appliances.
Do NOT select a location that exposes your alarm controller to direct sunlight, excess-
ive heat, moisture, vapors, chemicals or dust.
Do NOT install this equipment near water. (e.g., bath tub, kitchen/laundry sink, wet
basement, near a swimming pool).
Do NOT install this equipment and accessories in areas where risk of explosion
exists.
Do NOT connect this equipment to electrical outlets controlled by wall switches or
automatic timers.
AVOID interference sources.
AVOID installing equipment near heaters, air conditioners, ventilators, and refri-
gerators.
AVOID locating equipment close to or on top of large metal objects (e.g., wall studs).
See "Locating Detectors and Escape Plan" on page 49 for information on locating
smoke and CO detectors.
SAFETY Precautions Required During Installation
NEVER install this equipment during a lightning storm.
l
Position cables so that accidents can not occur. Connected cables must
l
NOT be subject to excessive mechanical strain.
IMPORTANT NOTE FOR INTERNATIONAL MARKET (EU,
AUS, NZ)!
This equipment is stationary-fixed and must be installed by skilled persons only
(skilled person is defined as a person with relevant education or experience to enable
him or her to identify hazards and to take appropriate actions to reduce the risks of
injury to themselves and others). It must be installed and used within an environment
that provides the pollution degree max 2, over voltages category II, in non-hazardous,
indoor locations only.
When using equipment connected to the mains and/or to the telecommunication net-
work, there are basic safety instructions that should always be followed. Refer to the
safety instructions provided with this product and save them for future reference.
To reduce the risk of fire, electric shock and/or injury, observe the following:
Do not attempt to service this product yourself. Opening or removing the cover may
expose you to dangerous voltage or other risk. Refer servicing to skilled persons.
Use authorized accessories only with this equipment. DO NOT leave and/or deposit
ANY object on the top of the cabinet of this equipment! The cabinet as it is installed on
the wall is not designed to support any supplementary weight!
Do not spill any liquids on the cabinet or equipment.
Do not touch the equipment and its connected cables during an electrical storm; there
may be a risk of electric shock.
Never touch uninsulated wires or terminals unless the equipment has been dis-
connected from the mains supply and from the telecommunication network!
Ensure that cables are positioned so that accidents cannot occur. Connected cables
must not be subject to excessive mechanical strain.
Do not use the Alarm system to report a gas leak if the system is near a leak.
These safety instructions should not prevent you from contacting the distributor
and/or the manufacturer to obtain any further clarification and/or answers to your con-
cerns.
iotega Wireless Security and Automation System
- 1 -