2.2, Set Operation Mode Enable - Polaris DP-20 User Manual

4. If necessary, press the SENSOR key to select
5. Press the ENTER key to enter the DEADBAND
6. Use the ARROW keys to adjust the Deadband
7. Press the ENTER key to store the change or
3X.2.2, Set Operation Mode Enable
1. Press the SETUP key to enter the Setup
2. Use the ARROW keys to scroll until SPECIAL
3. Press the ENTER key to enter the Special
4. Use the ARROW keys to scroll until SET
5. Press the ENTER key to enter the Set Mode
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
the desired sensor mode as indicated on line 1.
menu. The current value will begin flashing on
line 4.
to the desired setting as indicated on line 4. As
an ARROW key is held down, the speed of the
change increases. The default range of the
Deadband adjustment is 80% of the sensor
bandwidth, but this range will be limited if a
Guide Point Shift above 10% is being used.
The Deadband change is effective immediately,
but not yet stored.
press the MANUAL key to abort the change.
The system will exit the setup menus, and
return to the Operator Level.
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
is displayed on line 4.
Menus. The DEADBAND
displayed.
MODE ENABLE is displayed on line 3. The
current selection is displayed on Line 4.
Enable menu. The current selection will begin
flashing on line 4. The last digit of the menu
number will vary according to the current
selection.
DP-20 WEB GUIDE CONTROLLER
×
SETUP (MAN)
DEADBAND
-ÜÜÜÜÜÜÜ+
×
SETUP (MAN)
DEADBAND
-ÜÜÜÜÜÜÜ+
×
SETUP (MAN)
DEADBAND
-ÜÜÜãÜÜÜ+
×
×
SETUP (MAN)
SELECT MENU
BASIC
×
SETUP (MAN)
SELECT MENU
SPECIAL
×
SETUP (MAN)
menu will be
DEADBAND
-ÜÜÜÜÜÜÜ+
×
SETUP (MAN)
SET MODE ENABLE
|AUTO|SC
×
SETUP (MAN)
|AUTO|SC
|NO
6
6-13
3A.2.1
0.0%
3A.2.1.1
0.0%
3A.2.1.1
10.0%
3A
MANUAL
-ãããããáÜÜÜÜ+
3A.1
3A.2
3A.2.1
0.0%
3A.2.2
|MAN |
3A.2.2.1
|MAN |
|NO |YES |
Figure Sheet 1-862-D