1.4, Calibration, Edge Sensors - Polaris DP-20 User Manual

5. Press the ENTER key to allow adjustment of
6. Use
7. Press the ENTER key to store the change or
3X.1.4, Calibration, Edge Sensors
CAUTION: Do NOT preform calibration when using an SC-100 capacitance sensor with a DP-
1. Press the SETUP key to enter the Setup
2. Press the ENTER key to enter the BASIC
3. Use
4. Press
5. If necessary, use the ARROW keys to select
6. Press the ENTER key to begin the calibration.
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
the Guide Polarity. The current Guide Polarity
setting will begin flashing on line 4.
the ARROW
POLARITY to the desired setting as indicated
on Line 4.
press the MANUAL key to abort the change.
The system will exit the setup menus, and
return to the Operator Level.
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
Menus. The GAIN menu will be displayed.
the ARROW
CALIBRATION is displayed on line 3.
the ENTER
CALIBRATION menu. SELECT SENSOR will
be displayed on line 3. If Center Guiding was
the current sensor mode, the sensor mode is
forced to Edge Left (X5).
the desired sensor (Edge Left or Edge Right) to
be calibrated. The associated sensor connector
is displayed on line 4.
UNCOVER SENSOR will be displayed on line
2. Remove all materials from the sensor field of
view (see graphic at right). The sensor signal is
displayed on Line 3.
DP-20 WEB GUIDE CONTROLLER
keys to change
20.
keys to scroll until
key to enter
× 3A.1.3.1
SETUP (MAN)
GUIDE POLARITY
-
the
× 3A.1.3.1
SETUP (MAN)
GUIDE POLARITY
+
MANUAL
× -ãããããáÜÜÜÜ+
×Ø 3C.1
SETUP (MAN)
SELECT MENU
BASIC
×Ø 3C.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
×Ø 3C.1.4
SETUP (MAN)
CALIBRATION
the
× 3A.1.4.1
SETUP (MAN)
SELECT SENSOR
(X5)
Ø 3B.1.4.1
SETUP (MAN)
SELECT SENSOR
(X4)
Ø 3B.1.4.2
UNCOVER SENSOR
-ÜÜÜÜÜÜÜÜÜÜ+
Web
Sensor
Figure Sheet 1-862-D
6
6-3
3A
0%