1.8, Measurement - Polaris DP-20 User Manual

3X.1.8, Measurement
1. Press the SETUP key to enter the Setup
2. Press the ENTER key to enter the BASIC
3. Use
4. Press the ENTER key to view the Measurement
5. Use the ARROW keys to scroll to the desired
6. Use the ARROW keys to scroll to the desired
7. Use the ARROW keys to scroll to the desired
8. Use the ARROW keys to scroll to the desired
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
Menus. The GAIN menu will be displayed.
the ARROW
MEASUREMENT is displayed on line 3.
menus. The level of the guiding signal from the
Left Edge Sensor (Line Center if a line sensor
is being used) is displayed on Line 4. This
signal has been scaled by values which were
determined during the Sensor Calibration
procedure.
Measurement menu. Next in the list is the Right
Edge Sensor (Line Edge if a line sensor is
being used The guiding signal is displayed on
Line 4. This signal has been scaled by values
which were determined during the Sensor
Calibration procedure.
Measurement menu. Next in the list is the
Servo-Center Sensor. The sensor signal is
displayed on Line 4.
Measurement menu. Next in the list is the
TACHOMETER. The tachometer signal is
displayed on Line 4.
Measurement menu. Next in the list is the
MOTOR TYPE. The motor type is displayed on
Line 4.
DP-20 WEB GUIDE CONTROLLER
keys to scroll until
6
6-11
×Ø 3C.1
SETUP (MAN)
SELECT MENU
BASIC
×Ø 3C.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
×Ø 3C.1.8
SETUP (MAN)
MEASUREMENT
×Ø 3C.1.8.1
MEASUREMENT
× SENSOR (X5)
-ããããÜÜÜÜ+ 50%
ý 3D.1.8.1
MEASUREMENT
ý SENSOR (X4)
-ããããÜÜÜÜ+ 50%
×Ø 3C.1.8.2
MEASUREMENT
Ø SENSOR (X4)
-ããããÜÜÜÜ+ 50%
Ł 3E.1.8.2
MEASUREMENT
Ł SENSOR (X4)
-ããããÜÜÜÜ+ 50%
×Ø 3C.1.8.3
MEASUREMENT
~ƒ SENSOR (X2)
-ããããÜÜÜÜ+ 50%
×Ø 3C.1.8.4
MEASUREMENT
TACHOMETER
-ããããÜÜÜÜ+ 0%
×Ø 3C.1.8.5
MEASUREMENT
MOTOR TYPE
1.3A MOTOR 14K
Figure Sheet 1-862-D