Operator Interface; Function Of The Operator Level Keys - Polaris DP-20 User Manual

Function of the Operator Level Keys

06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
AUTOMATIC This key initiates the Automatic mode. Correction is
applied to the web by moving the guide in response to the output of the
sensor(s) that has been selected.
SERVO-CENTER
guide is centered in its travel in response to the output of the Servo-
Center transducer (if installed).
MANUAL This key initiates the Manual mode. No correction is applied
to the guide. This key is also used to abort changes made in the Setup
Menus and to exit the Setup Menus.
SENSOR This key is used to select the sensor(s) to be used for
monitoring the web position when the system is in Automatic mode.
Sensor selection is allowed in Manual and Servo-Center modes only.
SETUP This key is used to enter the Setup Menus for configuring and
adjusting the guiding system.
- ARROW This key is used to jog the guide. The direction of guide
movement is configurable. This key is also used during setups to scroll
through the setup menus and to adjust setup parameters.
ENTER This key is not used at the Operator Level. It is used while in
the Setup Menus to enter the selected menu and to store modified
parameters.
+ ARROW This key is used to jog the guide. The direction of guide
movement is configurable. This key is also used during setups to scroll
through the setup menus and to adjust setup parameters.
DP-20 WEB GUIDE CONTROLLER
2

OPERATOR INTERFACE

This key initiates the Servo-Center mode. The
2
2-1
Figure Sheet 1-862-D