3, Measurement - Polaris DP-20 User Manual

3. Press the ENTER key to allow adjustment of
4. Use the ARROW keys to adjust the System
5. If desired, press both of the ARROW keys
6. Press the ENTER key to store the change or
1X.3, Measurement
1. Press the SETUP key to enter the Setup
2. Use
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
the System Guide Point. The current Guide
Point value will begin flashing on line 4.
Guide Point to the desired position. The LCD
Panel is scaled to ±100% from the center of the
sensor bandwidth. The default range of the
Guide Point adjustment is ±80% of the sensor
bandwidth, but this range will be limited if a
Deadband above 10% is being used. ASC
settings can also limit the Guide Point range.
The Guide Point
immediately, but not yet stored.
simultaneously to reset the System Guide Point
to the center of the available range, as
indicated on line 4.
press the MANUAL key to abort the change.
The system will exit the setup menus, and
return to the Operator Level. The Guide Point
value (GP) will be displayed on Line 4 if the
value is not 0.
Menus. The GAIN menu will be displayed on
the LCD Panel.
the ARROW
MEASUREMENT is displayed on line 3.
DP-20 WEB GUIDE CONTROLLER
change is effective
keys to scroll until
4
4-2
×Ø 1C.2.1
SETUP (AUTO)
GUIDE POINT
-ÜÜÜåÜÜÜ+ 0.0%
×Ø 1C.2.1
SETUP (AUTO)
GUIDE POINT
-ÜÜÜÜåÜÜ+ +20.0%
×Ø 1C.2.1
SETUP (AUTO)
GUIDE POINT
-ÜÜÜåÜÜÜ+ 0.0%
1C
AUTOMATIC
×Ø -ãããããáÜÜÜÜ+
GP: +20.0%
×Ø 1C.1
SETUP (AUTO)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
×Ø 1C.3
SETUP (AUTO)
MEASUREMENT
Figure Sheet 1-862-D