3, Measurement - Polaris DP-20 User Manual

4. Use the ARROW keys to adjust the SC Guide
5. If desired, press both of the ARROW keys
6. Press the ENTER key to store the change or
2X.3, Measurement
1. Press the SETUP key to enter the Setup
2. Use
3. Press
4. Use the ARROW keys to scroll to the desired
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
Point to the desired position as indicated on
line 4.
simultaneously to reset the Servo-Center Guide
Point to 0.0% as indicated on line 4.
press the MANUAL key to abort the change.
The system will exit the setup menus, and
return to the Operator Level. The Servo-Center
Guide Point value will be displayed on Line 4 if
the value is not 0.
Menus. The SC GAIN menu will be displayed
on the LCD Panel.
the ARROW
MEASUREMENT is displayed on line 3.
the ENTER
Measurement menus. The level of the guiding
signal from the Left Edge Sensor (Line Center
if a line sensor is being used) is displayed on
Line 4. This signal has been scaled by values
which were determined during the Sensor
Calibration procedure.
Measurement menu. Next in the list is the Right
Edge Sensor (Line Edge if a line sensor is
being used). The guiding signal is displayed on
Line 4. This signal has been scaled by values
which were determined during the Sensor
Calibration procedure.
DP-20 WEB GUIDE CONTROLLER
keys to scroll until
key to view the
5
5-2
×Ø 2C.2.1
SETUP (SC)
~ƒ GUIDE POINT
-ÜÜåÜÜÜÜ+ -21.0%
×Ø 2C.2.1
SETUP (SC)
~ƒ GUIDE POINT
-ÜÜÜåÜÜÜ+ 0.0%
×Ø 2C
SERVO-CENTER
~ƒ -ããããÜÜÜÜÜÜ+
~ƒ GP: -21.0%
×Ø 2C.1
SETUP (SC)
~ƒ GAIN
ãÜÜÜÜÜÜÜÜÜ 5.0%
×Ø 2C.3
SETUP (SC)
MEASUREMENT
×Ø 2C.3.1
MEASUREMENT
× SENSOR (X5)
-ããããÜÜÜÜ+ 50%
ý 2D.3.1
MEASUREMENT
ý SENSOR (X4)
-ããããÜÜÜÜ+ 50%
×Ø 2C.3.2
MEASUREMENT
Ø SENSOR (X4)
-ããããÜÜÜÜ+ 50%
Ł 2E.3.2
MEASUREMENT
Ł SENSOR (X4)
-ããããÜÜÜÜ+ 50%
Figure Sheet 1-862-D