1.4, Calibration, Servo-Center Sensor - Polaris DP-20 User Manual

10. If the contrast is not sufficient for guiding,
3X.1.4, Calibration, Servo-Center Sensor
(The default calibration for the Servo-Center Sensor should be sufficient,
but this procedure may be used, if necessary).
1. Press the SETUP key to enter the Setup
2. Press the ENTER key to enter the BASIC
3. Use
4. Press
5. Use the ARROW keys to select the Servo-
6. Press the ENTER key to begin the calibration.
7. Press the ENTER key. COVER SENSOR will
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
FAILED will be displayed on line 2. Press the
MANUAL key to exit the setup menus and
return to the Operator Level. Repeat this
procedure, as necessary.
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
Menus. The GAIN menu will be displayed.
the ARROW
CALIBRATION is displayed on line 3.
the ENTER
CALIBRATION menu. SELECT SENSOR will
be displayed on line 3.
Center Sensor. will be displayed on line 1
~ƒ
and (X2) will be displayed on line 4.
UNCOVER SENSOR will be displayed on line
2. Position the flag such that it is located away
from the surface of the sensor (see graphic at
right). The sensor signal is displayed on Line 3
of the LCD Panel.
be displayed on line 2. Position the flag such
that it is positioned directly in front of the sensor
and is fully covering the sensor (see graphic at
right). The sensor signal is displayed on Line 3
of the LCD Panel.
DP-20 WEB GUIDE CONTROLLER
keys to scroll until
key to enter the
6
6-7
Ł 3E.1.4.6
FAILED
-áÜÜÜÜÜÜÜÜÜ+ 3%
× 3A.1
SETUP (MAN)
SELECT MENU
BASIC
× 3A.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
× 3A.1.4
SETUP (MAN)
CALIBRATION
× 3A.1.4.1
SETUP (MAN)
SELECT SENSOR
(X5)
~ƒ 3F.1.4.1
SETUP (MAN)
SELECT SENSOR
(X2)
~ƒ 3F.1.4.2
UNCOVER SENSOR
-ÜÜÜÜÜÜÜÜÜÜ+ 0%
Sensor
Flag
~ƒ 3F.1.4.3
COVER SENSOR
-ãããããããããá+ 95%
Sensor
Flag
Figure Sheet 1-862-D