1.5, Auto Setup - Polaris DP-20 User Manual

8. Press the ENTER key. If the contrast is
9. If the contrast is not sufficient, FAILED will be
3X.1.5, Auto Setup
Sensor Calibration should be performed prior to performing Auto Setup. If
a line sensor is being used, the icons and screen numbers will
correspond to the sensor mode that is selected.
1. Position the the edge of the web, or the center
2. Press the SETUP key to enter the Setup
3. Press the ENTER key to enter the BASIC
4. Use the ARROW keys to scroll until AUTO
5. If necessary, press the SENSOR key to select
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
sufficient, SUCCESSFUL will be displayed for a
few seconds on line 2, then the unit will
automatically exit the menus and return to the
Operator Level.
—
OR
displayed on line 2. Press the MANUAL key to
exit the setup menus and return to the Operator
Level. Repeat this procedure, as necessary.
or edge of the line in the center of the sensor
field of view. (See the appropriate graphic at
right). The ARROW keys may be used.
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
Menus. The GAIN menu will be displayed.
SETUP is displayed on line 3.
the desired sensor mode as indicated on line 1
of the LCD Panel.
DP-20 WEB GUIDE CONTROLLER
—
6
6-8
~ƒ 3F.1.4.4
SUCCESSFUL
-ãããããããããá+ 95%
3A
MANUAL
× -ãããããáÜÜÜÜ+
~ƒ 3F.1.4.6
FAILED
-áÜÜÜÜÜÜÜÜÜ+ 3%
Edge Guiding Line Center
Center Guiding Line Edge
× 3C.1
SETUP (MAN)
SELECT MENU
BASIC
× 3A.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
× 3A.1.5
SETUP (MAN)
AUTO SETUP
Ø 3B.1.5
SETUP (MAN)
AUTO SETUP
Figure Sheet 1-862-D