5.3, Set Asc Source - Polaris DP-20 User Manual

10. Press the ENTER key to store the new ASC
3X.5.3, Set ASC Source
This procedure is used to select the source of the signal that ASC acts on.
Only special applications require the ASC Source to be changed from the
default settings. The ASC Source is configurable for each sensor mode.
1. Press the SETUP key to enter the Setup
2. Use the ARROW keys to scroll until CUSTOM
3. Press the ENTER key to enter the Custom
4. Use the ARROW keys to scroll until SET ASC
5. If necessary, press the SENSOR key to select
6. Press the ENTER key to enter the SET ASC
7. Use the ARROW keys to select the desired
8. Press the ENTER key to store the new ASC
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
LIMITS, or press the MANUAL key to abort the
changes. The system will exit the setup menus,
and return to the Operator Level.
Menus. The SELECT MENU screen will be
displayed.
is displayed on line 4.
Menus. The ASC CONTROL menu will be
displayed.
SOURCE is displayed on lin 3. The current
setting is displayed on line 4.
the desired sensor mode.
SOURCE menu. The current setting will begin
flashing.
setting.
SOURCE, or press the MANUAL key to abort
the change. The system will exit the setup
menus, and return to the Operator Level.
DP-20 WEB GUIDE CONTROLLER
6
6-34
3B
MANUAL
Ø -ãããããáÜÜÜÜ+
× 3A.1
SETUP (MAN)
SELECT MENU
BASIC
× 3A.5
SETUP (MAN)
SELECT MENU
CUSTOM
× 3A.5.1
SETUP (MAN)
ASC CONTROL
OFF
× 3A.5.3
SETUP (MAN)
SET ASC SOURCE
×
Ø 3B.5.3
SETUP (MAN)
SET ASC SOURCE
Ø
Ø 3B.5.3.1
SETUP (MAN)
SET ASC SOURCE
× Ø ×Ø
Ø 3B.5.3.1
SETUP (MAN)
SET ASC SOURCE
× Ø ×Ø
3B
MANUAL
Ø -ãããããáÜÜÜÜ+
Figure Sheet 1-862-D