Fiat Bravo Service Manual page 339

Hide thumbs Also See for Bravo:

Table of Contents

Gearbox and differential

Removing-refitting

1. Rear attachment of gearbox support tool

2. Remove the engine mounting, gearbox side.

3. Manoeuvre the hydraulic jack as appropri-

ate in order to disengage the gearbox from

the attachment studs and surrounding

parts. Gradually lower the jack and with-

draw the gearbox.

4. When fitting the engine mounting, gear-

box side, to avoid creating stresses on the

sealing surfaces between the mounting

and the gearbox, resulting in deformation

and subsequent oil leak, closely follow the

bolt tightening sequence below:

- Tighten bolts (1) and (2) to a prelimi-

nary torque di 0.5 daNm;

- Tighten bolts (3) and (4) to a prelimi-

nary torque of 0.5 daNm, then tighten to

the specified torque;

- Tighten the bolts (1) and (2) to the

specified torque.

For the remaining refitting operations, re-

verse the procedure described for removal.

Before fitting the bellhousing in the car,

check that the clutch release bearing is

positioned correctly on the gearbox main-

The oil level in the gearbox must be 9

mm below the oil filler plug hole.

Chapters

Table of Contents