Fiat Bravo Service Manual page 307

Hide thumbs Also See for Bravo:

Table of Contents

Gearbox and differential

Removing - refitting

1. Remove the plastic wheelarch protection

on the gearbox by undoing the bolts and

retaining button shown in the figure. To

withdraw the protection, it is also neces-

sary to disconnect the brake pad wear

sensor connector (repeat the procedure

on the other side).

2. Remove the nut securing the steering tie¬

-rod end, then withdraw the latter from

the vertical link arm using the puller

(repeat the procedure for

the other tie-rod end).

3. Remove the nuts securing the vertical link

(gearbox and timing side) to the damper.

4. Rotate the vertical link as appropriate so

as to withdraw the drive shaft from the

wheel hub (repeat the operation for the

other drive shaft).

Chapters

Table of Contents