Bravo-Brava
Copyright
Fiat
Auto
ft
16v
Gearbox and differential
Removing - refitting
1. Remove the engine mounting, gearbox side.
2. Remove the bottom bolts securing the
bellhousing to the engine block.
3. Remove the nuts securing the first section of
the exhaust pipe to the manifold, to enable
the power unit to be moved forwards and so
facilitate withdrawal of the gearbox. If this is
still not sufficient, disconnect the coolant
inlet and outlet pipes from the heater.
4. Manoeuvre the hydraulic jack as appropri-
ate to disengage the gearbox from its at-
tachment studs and the surrounding com-
ponents. Gradually lower the jack and
withdraw the gearbox complete with drive
shafts.
5. If the gearbox is to be overhauled, drain
the oil by undoing the plug (arrowed) and
disconnect the two drive shafts, removing
the gaiter retaining clips.
2 1 - 2 7 .
27