Fiat Bravo Service Manual page 182

Bravo-Brava
m
Copyright Fiat Auto
1 0
16v
ENGINE IDLE SPEED ACTUATOR
(step motor) (WEBER B02)
The actuator is fitted to the butterfly valve case and consists
of:
- An electric step motor with two windings in the stator
- A worm and screw reduction unit that converts rotato-
In order to idle, i.e. with throttle (4) fully closed, the en-
gine needs a certain amount of air (Qo) and fuel to over-
come internal friction and maintain rpm levels.
To the quantity of air Qo that leaks through the closed but-
terfly valve (4) during idling, an additional quantity of air
Q must be added to allow the engine to maintain rpm lev-
els constant, particularly during warm up and when elec-
trical users or external loads are activated (air conditioner,
automatic transmission, etc).
To achieve this result, the system uses a step motor (1)
fastened to butterfly valve case (5) controlled by E C U (6)
which moves a rod fitted with a plunger (3) during opera-
tion. This alters the cross-section of by-pass duct (2) and
thus the amount of air (Qo + Q) taken in by the engine.
In order to govern this type of action, the E C U uses an-
gular engine speed and coolant temperature input from
the relevant sensors.
3 5
1. Bearing
2. Lead screw
3. Coils
4. Magnets
and a rotor that contains a certain number of permanent
magnet pairs.
ry motion into linear motion.
o-
+ 1 2 V
2 1
®
r ,
C , J
(34-©
—*—
Engine
Fuel system
5. Screw
6. Anti-rotation
grooves
7. Plunger
40
2 0
9
L D A j
L , B
i
' i
10.
3 5