Intermediate Shaft - Remote Control Assembly - Fiat Bravo Service Manual

Hide thumbs Also See for Bravo:

Table of Contents

Gearbox and differential

Intermediate shaft - Remote control assembly

REMOVING - REFITTING

Place the car on ramps, remove the front right

wheel, drain the gearbox oil and carry out the

operations listed below, which have already

been described above:

- Remove the right wheelarch cover

- Disconnect the right tie-rod end

- Disconnect the vertical link and drive shaft

from the joint.

1. Undo the bolts securing the intermediate

shaft to the mounting.

2. Withdraw the intermediate shaft from its

seating, then remove the dust excluder.

3. Withdraw the intermediate shaft from the

engine compartment.

4. Check that the intermediate shaft (1) is

not deformed or out of true; check that the

bearing (2) does not show signs of over-

heating, scoring or excessive wear.

spare part, so if it is faulty, the

plete intermediate

REMOTE CONTROL ASSEMBLY

To remove and refit the remote control as-

sembly, refer to the "Remote control assem-

bly" section for the 1581 16v engine.

is not supplied

shaft must be re-

Table of Contents