Fiat Bravo Service Manual page 268

E n g i n e
Fuel system
10
56
Removing-refitting ignition coils
Proceed with the removal of the ignition coils
by carrying out the following operations:
- disconnect the electrical connector;
- undo the two fixing bolts and remove the
coil, extracting it from the housing.
NOTE
Removing-refitting ignition power module
Remove the ignition power module carrying
out the following operations:
- disconnect the electrical input and output
connectors (arrow);
- undo the two fixing bolts and remove the
module.
P4A56BJ04
Bravo-Brava
The coil is fitted with an extension
made from a silicon material with a
high die/electric power
which there is a pressure switch with
a spring loading.
Do not dismantle the two compo-
nents so as not to risk losing the in-
ternal contact or getting it dirty.
In the case of replacement, it is not
necessary to separate the coil from
the extension because the complete
coil/extension assembly is available
as spares.
Checking primary circuit coil resis-
tance
The resistance is checked by follow-
ing the diagram.
Primary resistance: 0.6 ± 0.06 ohm
ft**
inside of
Print no. 506.670