Setting The Cutting Mode - DURKOPP ADLER 581 Operating Instructions Manual

56
5.2.6

Setting the cutting mode

On the display, the field (1) indicates the cutting mode. The cutting
mode determines when and whether a buttonhole is to be cut during
the sewing process.
For cutting mode, you can switch between the following parameters:
Parameters for cutting mode
Parameter Function
= No cutting
0
= Cut after the seam end (Cut After)
CA
= Cut before the seam beginning (Cut Before)
CB
Fig. 41: Setting cutting mode in sequential mode
(1) - Cutting mode
To set the cutting mode:
1. Use the button to navigate to the field Cutting mode (1).
2. Press the
 The cursor flashes.
button.
Operating Instructions 581 - 01.0 - 05/2016
Programming
①