DURKOPP ADLER 581 Operating Instructions Manual page 114

112
7. Press the
 The sewing motor moves into the test position 3 (looping
stroke right).
The following appears on the display:
Fig. 67: Looper adjust. (5)
You can check the looper setting and, if required, set as described
previously.
When you press the
tool appears on the display (see following table).
Important
When setting the needle bar height, you need to choose the
position such that the entire needle eye can be seen below the
left looper tip!
button.
button, the next test position of the sewing
Operating Instructions 581 - 01.0 - 05/2016
Programming