Table of Contents
Advertisement
Additional equipment
14.2 Setting the tape feeding and tape cutting device
Setting the tape feed
Fig. 120: Setting the tape feeding and tape cutting device (1)
(1) - Guide
(2) - Guide
To set the tape feed:
1. Loosen the screws at guides (1), (2) and (3).
2. Set the guides in such a way that the strip is fed precisely.
3. Tighten the screws at guides (1), (2) and (3).
Setting the tape length
The tape length is set at the OP7000 control panel ( p. 199).
Service Instructions 745-35-10 D - 00.0 - 10/2017
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you set the tape
feeding and tape cutting device.
①
②
(3) - Guide
③
135
Advertisement
Table of Contents
