DURKOPP ADLER 581 Operating Instructions Manual page 172

Error Meaning
8251 Fault during ADSP
– booting or booting
8258
9000 Seam appearance
– fault
9004
9009 Cutting punch is not in
position
170
Possible cause
• Internal error
• Disturbance
• Internal error
• Cutting position sensor
Operating Instructions 581 - 01.0 - 05/2016
Troubleshooting
Remedial action
• Switch the machine off and
on again
• Perform software update
• Contact Customer Service
• Switch the machine off and
on again
• Perform software update
• Reset the data ( Service
Instructions)
• Contact Customer Service
• Check the plug and cable
and replace, if required
• Replace the distributor board