Adjusting The Material Edge Stops - DURKOPP ADLER 581 Operating Instructions Manual

Setup
Operating Instructions 581 - 01.0 - 05/2016

7.15 Adjusting the material edge stops

WARNING
Risk of injury from sharp parts!
Punctures possible.
Only set the material edge stops when the
machine is switched off.
Fig. 100: Adjusting the material edge stops
①
(1) - Screws
To enable you to work precisely with the sewing material, you can
adjust the position of the material edge stops.
To set the material edge stops:
1. Insert the sewing material until it comes into contact with the
material edge stops (2) on the right and left sides.
2. Loosen the screws (1) on the right and left sides.
3. Set the sewing position by moving the material edge stops (2)
back and forth.
4. Re-tighten the screws (1).
②
(2) - Material edge stops
153