Page 3
Table of Contents Components in the parts set ............. 3 Fitting the sewing lamp.............. 4 Removing components ..............5 Fitting the housing with printed circuit board ........ 7 Additional Instructions 581 - 00.0 -02/2015...
Components in the parts set Components in the parts set The parts set 0580 101644 is intended for class 581 machines. Before fitting, check that the scope of delivery of the parts set is correct. Part no. Quantity Designation 0791 581716 EN...
2. Remove the finger protection. 3. Detach the housing. 4. Detach the head cover. 5. Remove the head cover. 6. Remove the housing. Now you can fit the new housing with the printed circuit board. Additional Instructions 581 - 00.0 - 02/2015...
(2) - Screws 3. Remove 3 screws (3) (width across flats 3) from the housing for the drive belts (4). Fig. 3: Detaching the housing ④ ③ (3) - Screws (4) - Housing Additional Instructions 581 - 00.0 - 02/2015...
Page 8
4. Loosen the screws on the head cover (5). 5. Remove the head cover (5). 6. Remove the housing for the drive belts (4). Fig. 4: Removing the head cover ⑤ (5) - Head cover Additional Instructions 581 - 00.0 - 02/2015...
2. Connect the X411 cable (3) to the tab connector of the printed circuit board (2). Fig. 6: Connecting the cable ③ (3) - X411 cable 3. Secure the housing with the 3 screws ( 2.1 Removing components, pg. 5). Additional Instructions 581 - 00.0 - 02/2015...
Page 10
Fitting the sewing lamp 4. Retighten the head cover. 5. Fit the finger protection. 6. Insert the clamping plates (see Operating Instructions). Additional Instructions 581 - 00.0 - 02/2015...
Page 12
DÜRKOPP ADLER AG Potsdamer Str. 190 33719 Bielefeld Germany Phone: +49 (0) 521 925 00 E-mail: service@duerkopp-adler.com www.duerkopp-adler.com...