DURKOPP ADLER 581 Operating Instructions Manual page 162

160
Symbol Description
At the start of sewing the
needle is in the threading
position
No compressed air
available, or the pressure is
too low
A prohibited cutting
combination was selected
(ONLY for Multiflex)
The sewing process stops
(ONLY for 141, 341 with
integrated and activated
gimp monitoring)
The serial number of the
machine has not been
entered
Remedial action
• Press the button on the
head cover
• Switch the machine off
and on again
• Switch off the machine
• Ensure the supply of
sufficient compressed air
• Switch on the machine
• In the control, check and
adjust the data for the
blade and cutting block set
• If necessary, insert and
set an appropriate blade
and cutting block
• The sewing process can
be continued with the OK
button or button 2, or
stopped with the ESC
button or button 1
• Press the OK button
• Contact DA service
Operating Instructions 581 - 01.0 - 05/2016
Troubleshooting