Safety Features - Vermont Castings SDDVTCBSB Installation & Operating Manual

Setting up Blank Screen or Constant Display in Idle
(Figure 71)
There is an option to set up how the LCD displays and
functions when the transmitter is in idle. There are two
choices:
• A) Mode. When the transmitter is in idle, the icons in the
"touch area" (timer, thermostat, blower, light and AUX)
will disappear, as shown in the figure on the left. When
any of the touch buttons is pressed, those icons will
appear and are ready to operate (default).
• B) Mode. The transmitter always displays all available
icons showing current status of timer, thermostat, blower,
light and AUX as shown in the figure on the right.
Press TIMER and THERMO buttons at the same time for 3
seconds to toggle between A) and B).
• When the current setting is A), touch any place in the
touch area to bring up the icons then press TIMER button
and THERMO button at the same time for 3 seconds.
The backlight will flash once to indicate that the setting
has changed to B).
• When the current setting is B), pressing TIMER button
and THERMO button at the same time for 3 seconds will
switch to A) Mode. The touch area icons will disappear.
Figure 71

Safety Features

FP2659
blank screen
Low Battery Detection
When low battery condition occurs, the transmitter will
turn off the stove.
Battery voltage is checked every one minute. When the
battery voltage is low, the LCD displays a low battery icon
which will exist in all modes.
• The transmitter will not operate with low battery voltage.
Change the batteries before the batteries become too
weak for normal operations.
Power On Initialization
After the power-on initialization, the transmitter sends a signal
to turn off the stove.
43 Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18
Thermal Shutdown
When the ambient temperature is more than 99°F, the
transmitter will turn off the stove.
• The LCD will display "HI".
• The Transmitter will not function until the room
temperature has dropped below 99 degree Fahrenheit.
Low Temperature Condition
When the ambient temperature is less than 40 degrees
Fahrenheit, the LCD will display "LO", and NO SIGNAL will
be sent to turn on the appliance.
All functions still remain the same for both Manual
Mode and Thermostat Mode
Child-proof Protection
The child-proof icon will be shown when the
child-proof mode is activated by pressing the
ON button and the OFF button at the same time
for three seconds.
• Enter childproof mode by pressing and
holding both the ON button and the OFF
button simultaneously for 3 seconds. The
Childproof indicator will be shown on the
LCD.
• Deactivate childproof mode by pressing and
holding the ON button and the OFF button
simultaneously for 3 seconds again. The Childproof
indicator disappears on the LCD.
• The transmitter cannot be operated in childproof mode.
Using the Mounting Base (Figure 72)
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
Secure the mounting base on the wall with supplied screws.
For best viewing angle, make it the same height as your eyes.
Hang the transmitter on the hook of the mounting base, then
push down so the transmitter is flush to the mounting base.
FP2612
low battery
Figure 72 - Using the Mounting Base
FP2613
HI
FP2614
lo no child
FP2674
mounting base
3-90-20306760