Table of Contents
Advertisement
WARNING: If you do not follow these directions exactly, a fire or explosion may result
causing property damage, personal injury, or loss of life.
•
Do not try to light any appliance
•
Do not touch any electrical switch, do not use any phone in
your building
•
Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions
•
If you cannot reach your gas supplier, call the fire department
Before operating, smell all around the appliance area for gas odor. Be sure to smell near the floor because
some gases (propane) are heavier than air and will "pool" on the floor.
Use only your hand to push or turn the gas control dial. NEVER USE TOOLS. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified technician. Force or attempted repair may result in a fire or
explosion.
f i r e - p a r t s . c o m
The pilot will resist lighting on new installations due to
air in he gas supply line. It may take several minutes
to bleed air completely out of the gas plumbing
system through the pilot line.
This appliance has a pilot which is lit by a spark
ignition device (piezo). If the piezo fails, then light the
pilot using matches following the Match Lighting
instructions below.
1. STOP! Read the safety information on above.
2. Push in gas control knob slightly and turn clock-
wise
to OFF.
3. NOTE: Knob cannot be turned from PILOT to OFF
unless knob is pushed in slightly. Do not force.
4. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow the safety informa-
tion on page 13. If you do not smell gas, go on to
the next step.
5. Turn the control knob counterclockwise
PILOT and push in. Continue to hold the control
knob in and push the piezo ignitor button in until
the pilot lights.
1. Follow the "Lighting the Pilot" instructions steps 1 through 4.
2. Push the control dial in all the way and hold. Immediately light the pilot with a match. Continue to hold the
pilot for about one minute after the pilot is lit. Pilot should remain lit. If the pilot goes out, repeat Lighting the
Pilot steps 1 through 4 and this step 2.
For Your Safety Read Before Lighting
WHAT TO DO IF YOU SMELL GAS
Lighting the Pilot - RVK
to
Match Lighting
13
6. Continue to hold the control knob in for about one
(1) minute after the pilot is lit. Release the knob
and it will pop back up. Pilot should remain lit. If it
goes out, repeat steps 3 and 4.
7. If the knob does not pop out when released, stop
and call your service technician or gas supplier. If
the pilot will not stay lit after several tries, turn the
gas control knob to OFF and call your service
technician or gas supplier.
8. Turn gas control knob counterclockwise
ON. CAUTION: Be sure ON/OFF/RS switch is in
the off (middle) position. Also, the GWSK should
be in the OFF position and/or the remote should
be in the OFF position before turning the control
knob ON. If pilot goes out, repeat steps 4 and 5.
9. Turn ON/OFF/RS switch to ON or remote position.
Turn remote switch to ON
10. Flame is adjustable by rotating the HI/LO knob.
to
Advertisement
Table of Contents
