Vermont Castings SDDVTCBSB Installation & Operating Manual page 35

1. STOP! Read the safety information above.
2. This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the
burner by hand.
3. With five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information on Page 34. If you do not smell gas, go to next step.
4. Press the master switch to the "ON" (-) position. Within eight (8) seconds it will beep once. This indicates the
system is ready.
5. Press "ON " button. Sparker will spark and pilot flame will light.
6. Once pilot flame is established, the main burner flame will light automatically.
7. If the pilot will not stay lit after several tries, turn the master switch to "OFF" and call your service technician or gas
supplier.
OFF
Command Center
FP1913
Switch box
1. Turn master switch to "OFF".
8/08
2. Turn off all electrical power to the appliance if service is to be performed.
35
LIGHTING AND OPERATING INSTRUCTIONS
FOR RADVTSC MODELS
OFF
ON
TO TURN OFF GAS TO APPLIANCE
Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18
Master
Switch
ON
FP1914
Pilot w sparker
8/08
3-90-20306760