Safety Features - Vermont Castings Radiance RADVTSCCB Installation And Operating Instructions Manual

Radiance Direct Vent Gas Heater
®
Setting up Blank Screen or Constant Display in Idle
Figure 69
There is an option to set up how the LCD displays and func-
tions when the transmitter is in idle. There are two choices:
• A) Mode. When the transmitter is in idle, the icons in the
"touch area" (timer, thermostat, blower, light and AUX)
will disappear, as shown in the figure on the left. When
any of the touch buttons is pressed, those icons will ap-
pear and are ready to operate (default).
• B) Mode. The transmitter always displays all available
icons showing current status of timer, thermostat, blow-
er, light and AUX as shown in the figure on the right.
Press TIMER and THERMO buttons at the same time for
3 seconds to toggle between A) and B).
• When the current setting is A), touch any place in the
touch area to bring up the icons then press TIMER but-
ton and THERMO button at the same time for 3 sec-
onds. The backlight will flash once to indicate that the
setting has changed to B).
• When the current setting is B), pressing TIMER button
and THERMO button at the same time for 3 seconds
will switch to A) Mode. The touch area icons will disap-
pear.
Fig. 69

SAFETY FEATURES

FP2659
Low Battery Detection
blank screen
When low battery condition occurs, the transmitter
will turn off the stove.
Battery voltage is checked every one minute.
When the battery voltage is low, the LCD displays
a low battery icon which will exist in all modes.
• The transmitter will not operate with low bat-
tery voltage. Change the batteries before the batteries
become too weak for normal operations.
Power On Initialization
After the power-on initialization, the transmitter sends a
signal to turn off the stove.
20306759
Thermal Shutdown
When the ambient temperature is more than 99°F, the
transmitter will turn off the stove.
• The LCD will display "HI".
• The Transmitter will not function until the room tem-
perature has dropped below 99 degree Fahrenheit.
Low Temperature Condition
When the ambient temperature is less than 40 degrees
Fahrenheit, the LCD will display "LO", and NO SIGNAL
will be sent to turn on the appliance.
All functions still remain the same for both
Manual Mode and Thermostat Mode
Child-proof Protection
The child-proof icon will be shown when the
child-proof mode is activated by pressing the
ON button and the OFF button at the same
time for three seconds.
• Enter childproof mode by pressing and
holding both the ON button and the OFF
button simultaneously for 3 seconds. The
Childproof indicator will be shown on the
LCD.
• Deactivate childproof mode by press-
ing and holding the ON button and the
OFF button simultaneously for 3 seconds again. The
Childproof indicator disappears on the LCD.
• The transmitter cannot be operated in childproof
mode.
Using the Mounting Base
Figure 70
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
Secure the mounting base on the wall with supplied screws.
For best viewing angle, make it the same height as your
eyes.
Hang the transmitter on the hook of the mounting
base, then push down so
transmitter is flush to the
mounting base.
FP2612
low battery
Fig. 70 Using the Mounting Base
OPERATING INSTRUCTIONS
FP2613
HI
FP2614
lo no child
FP2674
mounting base
t h e
43