Initialization And Setting Up - Vermont Castings SDDVTCBSB Installation & Operating Manual

• The radio icon will be shown when the transmitter is
sending a signal.
• The low battery indication icon will be shown when the
battery voltage is low.
• The child-proof icon will be shown when the child-proof
mode is activated.
• The flame icon indicates the current flame height – Off,
Low, Medium and High
Touch Area
The touch area contains all touch buttons to control the
transmitter. It consists of two categories: menus and
adjustment arrows. The blue LED backlight lights up for 8
seconds when any of the touch buttons is pressed.
• The menus include TIMER, THERMO, LIGHT, FAN and
AUX.
• The adjustment arrows include ON/up and OFF/down.
Their default function is to adjust the flame height. When
a button from the menu is pressed, the ON/up and
OFF/down buttons will temporarily become adjustment
controls for the selected item. When the adjustment
is done, the ON/up and OFF/down buttons go back to
flame height controller again.
Logo Bar
The Logo Bar contains the brand logo: Signature Command
System.
Figure 61 - Functional areas of LCD Display
FP2646
TSFSC display
39 Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18
Initialization and Setting up / Installing Batteries (Figure
62)
The remote transmitter has two battery compartments, one
on each end of the transmitter. Always change all four (4)
batteries at the same time.
To install batteries,
1. Press down the battery door tab and pull out to remove
the battery door.
2. Install the batteries as indicated inside the battery
compartments.
3. Close the battery door by snapping in place.
4. When all four batteries are installed, the transmitter will
initialize for 5 seconds and then is ready for use.
5. The batteries should be replaced every 12 months or
when the low battery icon indicator is displayed.
Figure 62 - Replacing the battery
Changing Temperature Unit
FP2607
When batteries are installed in the transmitter, all available
install battery
icons on the LCD will be turned on then be cleared.
The LCD will display temperature unit: °F. Use ON ∆ to toggle
the units between °F and °C within the first 5 seconds.
The transmitter enters Manual Mode
The LCD displays room temperature with the chosen unit.
Battery
Door Tabs
3-90-20306760