Disassemble Vent Sections; Horizontal Termination Cap - Vermont Castings SDDVTCBSB Installation & Operating Manual

Figure 26 - Securing Horizontal Pipe Sections

Disassemble Vent Sections

To disassemble any two pieces of pipe, rotate either section
(Figure 27), so that the seams on both pipe sections are
aligned (Figure 28). They can then be carefully pulled apart.
Figure 27 - Rotate Seams for Disassembly
Figure 28 - Align and Disassemble Vent Sections
19 Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18

Horizontal Termination Cap

!
Risk of Fire! The telescoping flue section of the termination
cap MUST be used when connecting vent.
• 1-1/2" (38 mm) minimum overlap of vent and
telescoping flue section is required.
Failure to maintain overlap may cause overheating and
fire.
Note: For horizontal vent runs through a combustible
wall and framing dimensions, refer to appliance
installation manual.
Install the Horizontal Termination Cap
Attach slip section of cap to last vent section. Maintain 1
overlap between slip and vent sections.
Note: For installations using black pipe, slide the
decorative wall thimble over the last vent pipe before
connecting the termination to the pipe. When this
connection has been made, slide the wall thimble up to
the interior wall surface and attach with screws provided.
Secure termination cap to exterior wall using provided holes
and fasteners.
Vent termination must not be recessed in the wall. Siding
may be brought to the edge of the cap base.
!
Risk of Burns! Local codes may require installation of a
termination guard to prevent anything or anyone from
touching the hot cap.
Flash and seal as appropriate for siding material at outside
edges of cap.
When installing a horizontal termination cap, follow the cap
location guidelines as prescribed by current ANSI Z223.1
and CAN/CGA-B149 installation codes.
WARNING
CAUTION
3-90-20306760
⁄ "
1
2