Fuel Conversion - Vermont Castings SDDVTCBSB Installation & Operating Manual

Fuel conversion

!
This conversion kit shall be installed by a qualified service
agency in accordance with the manufacturer's instructions
and all applicable codes and requirements of the authority
having jurisdiction. If the information in these instructions
is not followed exactly, a fire, explosion or production of
carbon monoxide may result causing property damage,
personal injury or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer's instructions supplied with the kit.
!
The gas supply shall be shut off prior to disconnecting the
electrical power, before proceeding with the conversion
(Figure 74).
Gas Supply Inlet
Figure 74 - Attach the gas line to the right side of the valve.
Conversion Precautions
Before proceeding, turn control knob on valve to OFF and
ST226 ST226
turn gas supply OFF. Turn OFF any electricity that may be
attach gas line attach gas line
going to the appliance.
12/8/99 djt 12/8/99 djt
Conversion Procedure
• Remove stove front. Lift stove front up and then swing
bottom out and away to disengage from the stove body.
• Undo the right and left latches at the top of the glass
frame.
• Pull the top edge of the glass and frame assembly away
from the firebox face. Place the assembly out of the way
on a flat, padded surface such as a counter protected by
a towel.
• Remove the logset from the firebox.
46
WARNING
CAUTION
Shut
Main
off
Gas
Valve
Line
Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18
Valve Conversion - SDDVT Series Models
• Turn control knob to the OFF position, and shut off the
gas supply to the valve.
• Allow the valve to cool to room temperature.
• Remove the black protection cap by hand. (Figure 75)
Figure 75
• Insert a 5/32" or 4 mm Allen wrench into the hexagonal key-
CO138
way of the screw (Figure 76), rotate it counterclockwise
remove screw
until it is free and extract it. 6/07
• Check that the screw is clean and if necessary remove
dirt. Flip the screw. (Figure 77)
• Using the Allen wrench as shown in Figure 78, rotate the
screw clockwise and tighten until snug.
NOTE: Do not over-tighten the screw. Recommended to
grip the wrench by the short side.
Figure 77
CO140
turn screw
6/07
Figure 76
CO139
Allen wrench
6/07
Figure 78
CO139
Allen wrench
6/07
3-90-20306760