Vermont Castings SDDVTCBSB Installation & Operating Manual page 49

SDVTSC Models
• Using Torx T20 driver or slotted screwdriver, remove and
discard the regulator and rubber gasket in the face of the
valve (Figure 87).
• Install the new regulator with rubber gasket from the
conversion kit. Make sure the gasket is seated properly.
• Loosen the piloe fitting at the base of the pilote using
a 7/16" wrench. Remove the existing pilot orifice and
replace with the pilot orifice shipped with stove using
a flat head screw driver. When replacing the pilot for
service purpose replace the entire pilot.
• Convert the control box by using a small flat head
screwdriver. Lift the conversion cap from the control box
and replace with new one marked LP. Be sure to place
correctly. Figure 86
Regulator
Figure 87 - Valve Regulator
KT1196
SC valve regulator
Figure 88 - Convert Control Box
49
Rubber gasket
KT1193
conversion cap
Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18
All Models
Replace burner making sure venturi on bottom of ember
bed aligns with orifice and is seated properly on air shutter
assembly. Make sure burner is slid into place at a slight angle
and opposite to how it was removed. When burner is slid into
place, the three (3) pem studs should slide down through
clearance holes into the bottom of the control panel.
Thread and tighten 3/8" nuts back onto pem studs on
underneath side of control panel, reversing Step 1 shown
in Figure 84.
Refer to Log Installation section of this manual to reinstall
logs.
Place conversion label supplied with kit on rating plate.
Replace glass and stove front.
Restore gas to system and relight appliance according to
Lighting Instructions on page 32 (SDDVT models) or page
35 (SDVTSC models).
Leak check the system using a gas leak detector solution.
Relight the main burner in both the "HI" and "LO" positions
to verify proper burner ignition and operation.
Conversion is complete.
3-90-20306760