Assembly & Installation; Install The Optional Fan - Sddvt Models (Millivolt Only) - Vermont Castings SDDVTCBSB Installation & Operating Manual

Assembly & Installation
Tools Required
• Phillips screwdriver (stub)
• Utility knife
• Metal drill bit: size 28 (.140"/3.5mm)
• Flat-blade screwdriver
• Power drill
• Reciprocating saw
• 9/16" Wrench
• 1/2" Wrench
Parts Bag Contents:
• LP Conversion Kit
• Three (3) Vent Screws
• Two (2) Switch bracket screws
• Wood handle w/insert lifter (handle for operable door)
• Restrictor Plate
• 4" Starter pipe
• On-Off switch, housing, and wiring harness
• Three (3) Phillips round-head bolts, 1/4" – 20 x 1/2"
• One (1) Tube of Vent Gasket Cement
• Homeowner's Installation and Operating Manual
Unpack Stove
Using the 1/2" wrench remove the (4) lag bolts installed
through the shipping brackets and into the skid. Once the lag
bolts are removed, remove the shipping brackets from around
each leg leveller located at each leg with the 9/16" Wrench.
!
This appliance is equipped with a three-prong (grounded)
plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong
from this plug.
Install the Optional Fan – SDDVT models (Millivolt Only -
See page 27 for SC Models)
If you are installing the optional convection Fan Kit #2767
(FK26), continue here. It is easiest to install fan kit before
connecting gas line.
1. The fan kit includes a Blower Assembly and a Rheostat
Assembly, connected by a cable. (Figure 15) The Blower
Assembly mounts to the bottom rear of the stove, and the
Rheostat mounts to the valve cover plate. The assembly
includes a 'snapstat' which automatically turns the fan
On (or Off) above (or below) approximately 109°. The
Rheostat also provides a range of fan speed settings
from Off (which overrides the snapstat function) to High.
Unpack and inspect the Blower assembly. Confirm that
the fan spins freely.
14
WARNING
Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18
Not Used On
Stardance
Blower
Assembly
Figure 15 - Fan kit components.
2. Remove the rear skirt insert panel at the bottom of the
Rear Skirt (Figure 16) and fasten the blower assembly
ST473a
to the firebox back with the two Phillips pan-head bolts
Fan parts
originally installed in the firebox back. ('1', Figure 17)
#2767 FK26
9/29/00
3. Attach the snapstat assembly to the snapstat bracket
with two sheet-metal screws. ('2', Figure 17) Attach
the snapstat bracket to the stove with a hex-head bolt
passing through the bracket and into the stove base. ('3',
Figure 17)
4. The rheostat control switch attaches to the left side of the
valve bracket at the front of the stove. (Figure 18)
Rear Skirt
Sheet Metal Screws
Rear Skirt Insert
Figure 16 - Remove rear shroud.
Snapstat
Bracket
Snapstat/
Extension
Assembly
Rheostat
Assembly
ST313
fk26
install fan kit
rear skirt insert
1/24/00
3-90-20306760