Perform Engine Maintenance - Deutz Models; Calibrate The Platform Overload System (If Equipped) - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
D-6
Perform Engine Maintenance -
Deutz Models
Engine specifications require that
this procedure be performed every
1000 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz FL 2011 Operation Manual
(Deutz part number 0297-9929).
Deutz FL 2011 Operation Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fasteners
located under the engine tray. Swing the engine
tray out and away from the machine and secure
it from moving.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
3 - 44
D-7
Calibrate the Platform Overload
System (if equipped)
Yearly calibration of the platform overload system
is essential to safe machine operation. Continued
use of an improperly calibrated platform overload
system could result in the system failing to sense
an overloaded platform. The stability of the
machine is compromised and it could tip over.
1 Level the platform.
2 Determine the maximum platform capacity.
Refer to the machine serial plate.
84794
3 Using a suitable lifting device, place an
appropriate test weight equal to that of the
maximum platform capacity at the center of the
platform floor.
Genie S-40 and Genie S-45
January 2005
Genie specifications require that
this procedure be performed every
1000 hours of operation or yearly.
Perform this procedure with the
machine on a firm, level surface.
Part No. 102521
REV A