Checklist C Procedures; Perform Engine Maintenance - Deutz Models; Grease The Platform Overload Mechanism (If Equipped) - Genie S-40 Service Manual

January 2005
REV A
C-1
Perform Engine Maintenance -
Deutz Models
Engine specifications require that
this procedure be performed every
500 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz FL 2011 Operation Manual
(Deutz part number 0297-9929).
Deutz FL 2011 Operation Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fasteners
located under the engine tray. Swing the engine
tray out and away from the machine and secure
it from moving.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
Part No. 102521
Section 3 • Scheduled Maintenance Procedures

Checklist C Procedures

C-2
Grease the Platform Overload
Mechanism (if equipped)
Application of lubrication to the platform overload
mechanism is essential to safe machine operation.
Continued use of an improperly greased platform
overload mechanism could result in the system not
sensing an overloaded platform condition and will
result in component damage.
1 Locate the grease fittings on each pivot pin of
the platform overload assembly.
84794
2 Thoroughly pump grease into each grease fitting
using a mulit-purpose grease.
Genie S-40 and Genie S-45
Genie specifications require
that this procedure be performed
every 500 hours or 6 months,
whichever comes first. Perform
this procedure more often if dusty
conditions exist.
3 - 35