Turntable Rotation Components; Turntable Rotation Assembly - Genie S-40 Service Manual

January 2005
REV A
8-1

Turntable Rotation Assembly

How to Remove the Turntable
Rotation Assembly
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation.
Refer to Section 2, Hydraulic Hose
and Fitting Torque Specifications.
Perform this procedure with the
machine on a firm and level
surface.
1 Secure the turntable from rotating with the
turntable rotation lock pin.
Unlocked position
Locked position
Part No. 102521

Turntable Rotation Components

Genie S-40 and Genie S-45
Section 4 • Repair Procedures
2 Tag, disconnect and plug the hydraulic hoses
from the motor, brake and manifold. Cap the
fittings on the motor, brake and manifold.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not
allow oil to squirt or spray.
3 Attach a suitable lifting device to the turntable
rotator assembly.
f
e
d
a brake assembly
b drive hub
c backlash plate mounting bolts
d backlash plate
e manifold
f motor
c b
a
4 - 45