Traction Manifold Components, 2Wd (After Serial No. 7568) - Genie S-40 Service Manual

Section 4 • Repair Procedures
MANIFOLDS
7-9

Traction Manifold Components, 2WD (after serial no. 7568)

The traction manifold is mounted inside the drive chassis at the non-steer end.
Index
No. Description
1 Relief valve, 280 psi / 19.3 bar .......... GA ........ Charge pressure circuit ..................... 30-35 ft-lbs / 41-47 Nm
2 Flow divider/combiner valve .............. GB ........ Controls flow to drive motors
3 Check valve ....................................... GC ........ Drive circuit ....................................... 30-35 ft-lbs / 41-47 Nm
4 Check valve ....................................... GD ........ Drive circuit ....................................... 30-35 ft-lbs / 41-47 Nm
5 Flow divider/combiner valve .............. GE ........ Controls flow to drive motors
6 Orifice, 0.070 inch / 1.78 mm ............ GF ........ Equalizes flow across flow
4 - 36
Schematic
Item Function
in forward and reverse ................ 90-100 ft-lbs / 122-136 Nm
in forward and reverse ...................... 50-55 ft-lbs / 68-75 Nm
divider/combiner valve (item GB)
1
Genie S-40 and Genie S-45
January 2005
REV A
Torque
2
3
4
5
6
Part No. 102521