To do...
Configure the LSA arrival interval
NOTE:
The interval set with the lsa-arrival-interval command must be smaller than or equal to the interval set with
the lsa-generation-interval command.
Specifying the LSA generation interval
You can adjust the LSA generation interval to protect network resources and routers from being over
consumed by frequent network changes.
Follow these steps to configure the LSA generation interval:
To do...
Enter system view
Enter OSPF view
Configure the LSA
generation interval
NOTE:
When network changes are not frequent, LSAs are generated at the
become frequent, the LSA generation interval is incremented by
number of generation times) each time a LSA generation occurs until the
Disabling interfaces from receiving and sending OSPF packets
Follow these steps to disable interfaces from receiving and sending routing information:
To do...
Enter system view
Enter OSPF view
Disable interfaces from
receiving and sending OSPF
packets
Use the command...
lsa-arrival-interval interval
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
lsa-generation-interval
maximum-interval [ initial-interval
[ incremental-interval ] ]
Use the command...
system-view
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
silent-interface { interface-type
interface-number | all }
88
Remarks
Optional
1000 milliseconds by
default
Remarks
—
Required
Optional
By default, the maximum interval is 5
seconds, the minimum interval is 0
milliseconds, and the incremental
interval is 5000 milliseconds.
minimum-interval
. If network changes
incremental-interval
× 2
maximum-interval
Remarks
—
—
Optional
Not disabled by default
n-2
(n is the
is reached.