Ospfv3 Route Redistribution Configuration Example - HP FlexFabric 12900E Series Configuration Manual

3.3.3.3
4.4.4.4
# Display neighbor information on Switch D. Switch D is still the DR.
[SwitchD] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
1.1.1.1
2.2.2.2
3.3.3.3
4. Restart DR and BDR election:
# Use the shutdown and undo shutdown commands on interfaces to restart DR and BDR
election. (Details not shown.)
# Display neighbor information on Switch A. The output shows that Switch C becomes the BDR.
[SwitchA] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
2.2.2.2
3.3.3.3
4.4.4.4
# Display neighbor information on Switch D.
[SwitchD] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
1.1.1.1
2.2.2.2
3.3.3.3
The output shows that Switch A becomes the DR.

OSPFv3 route redistribution configuration example

Network requirements
As shown in
•
Switch A, Switch B, and Switch C are in Area 2.
•
OSPFv3 process 1 and OSPFv3 process 2 run on Switch B. Switch B communicates with
Switch A and Switch C through OSPFv3 process 1 and OSPFv3 process 2.
2 Full/BDR
1 Full/DR
OSPFv3 Process 1 with Router ID 4.4.4.4
Pri State
100 Full/DROther
0 Full/DROther
2 Full/BDR
OSPFv3 Process 1 with Router ID 1.1.1.1
Pri State
0 Full/DROther
2 Full/BDR
1 Full/DROther
OSPFv3 Process 1 with Router ID 4.4.4.4
Pri State
100 Full/DR
0 2-Way/DROther
2 Full/BDR
Figure 99:
00:00:35 0
00:00:33 0
Dead-Time InstID Interface
00:00:30 0
00:00:37 0
00:00:31 0
Dead-Time InstID Interface
00:00:36 0
00:00:35 0
00:00:33 0
Dead-Time InstID Interface
00:00:30 0
00:00:37 0
00:00:31 0
431
Vlan200
Vlan200
Vlan100
Vlan200
Vlan100
Vlan200
Vlan100
Vlan200
Vlan100
Vlan200
Vlan100