Configuring Ospf Network Management; Setting The Lsu Transmit Rate - HP FlexFabric 12900E Series Configuration Manual

Configuring OSPF network management

This task involves the following configurations:
•
Bind an OSPF process to MIB so that you can use network management software to manage
the specified OSPF process.
•
Enable SNMP notifications for OSPF to report important events.
•
Configure the SNMP notification output interval and the maximum number of SNMP
notifications that can be output at each interval.
To report critical OSPF events to an NMS, enable SNMP notifications for OSPF. For SNMP
notifications to be sent correctly, you must also configure SNMP on the device. For more information
about SNMP configuration, see the network management and monitoring configuration guide for the
device.
To configure OSPF network management:
Step
1. Enter system view.
2. Bind OSPF MIB to an
OSPF process.
3. Enable SNMP notifications
for OSPF.
4. Enter OSPF view.
5. Configure
notification output interval
and the maximum number
of SNMP notifications that
can be output at each
interval.

Setting the LSU transmit rate

Sending large numbers of LSU packets affects router performance and consumes a large amount of
network bandwidth. You can configure the router to send LSU packets at an interval and to limit the
maximum number of LSU packets sent out of an OSPF interface at each interval.
To set the LSU transmit rate:
Command
system-view
ospf mib-binding process-id
snmp-agent
[ authentication-failure | bad-packet |
config-error | grhelper-status-change
| grrestarter-status-change
if-state-change
lsa-originate
lsdb-approaching-overflow
lsdb-overflow
neighbor-state-change
nssatranslator-status-change
retransmit | virt-authentication-failure
| virt-bad-packet | virt-config-error |
virt-retransmit
virtgrhelper-status-change
virtif-state-change
virtneighbor-state-change ] *
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
the SNMP
snmp
trap-interval count trap-number
trap enable
| lsa-maxage
trap rate-limit interval
91
Remarks
N/A
By default, OSPF MIB is
bound to the process with the
smallest process ID.
ospf
|
|
|
|
By default,
|
notifications for OSPF are
|
enabled.
|
|
|
|
N/A
By default, OSPF outputs a
maximum of seven SNMP
notifications within
seconds.
SNMP
10