Configuring The Maximum Number Of Mbgp Routes For Load Balancing - HP A5500 SI Switch Series Configuration Manual

To do...
Enable the non-standard ORF
capability for a BGP peer/peer
group
Enter MBGP address family view
Enable the ORF IP prefix
negotiation capability for a BGP
peer/peer group
Table 8 Description of the both, send, and receive parameters and the negotiation result
Local parameter
send
receive
both
Configuring the maximum number of MBGP routes for load
balancing
Follow these steps to configure the number of MBGP routes for load balancing:
To do...
Enter system view
Enter BGP view
Enter IPv4 MBGP address family
view
Configure the maximum number
of MBGP routes for load
balancing
Use the command...
peer { group-name | ipv6-address
} capability-advertise orf non-
standard
ipv4-family multicast
peer { group-name | ip-address }
capability-advertise orf ip-prefix {
both | receive | send }
Peer parameter
receive
both
send
both
both
Use the command...
system-view
bgp as-number
ipv4-family multicast
balance number
231
Remarks
Optional
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
If this feature is not enabled, you
need to configure this command.
For more information about the
command, see the Layer 3—IP
Routing Command Reference.
—
Optional
Not supported by default.
Negotiation result
The ORF sending capability is enabled locally
and the ORF receiving capability is enabled on
the peer.
The ORF receiving capability is enabled locally
and the ORF sending capability is enabled on the
peer.
Both the ORF sending and receiving capabilities
are enabled locally and on the peer, respectively.
Remarks
—
—
—
Required
Not configured by default.