Authorized-Manager Ip-Source - Siemens SIMATIC NET Configuration Manual

Security and authentication
10.3 Management Access Control List
10.3.2.1

authorized-manager ip-source

Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefix-length(1-32)>}]
[interface[<interface-type<0/a-b,0/c,...>]
[vlan<a,b or a-b or a,b,c-d>]
The parameters have the following meaning:
Parameter
ip-address
subnet-mask
prefix-length
interface
interface-type
0/a-b,0/c,...
vlan
a,b or a-b or
a,b,c-d
service
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The IP address 0.0.0.0 means "any manager"
430
[<interface-type<0/a-b,0/c,...>]]
Description
Specifies the network or the IP address for
which the IP manager is authorized
Subnet mask that restricts the authorization
Decimal representation of the mask as a number
of "1" bits
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of a VLAN or VLAN range
Specifies the services for which the manager is
authorized.
You can select several options.
[service[snmp][telnet][http][https][ssh]]
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
Enter a valid IPv4 address or a
network
Enter a valid mask
1 .. 32
-
Enter a valid interface.
-
enter a valid VLAN or VLAN
range
•
snmp
•
telnet
•
http
•
https
•
ssh