Wlan Security Ap-Radius-Authenticator Address - Siemens SIMATIC NET Configuration Manual

10.2.2.3

wlan security ap-radius-authenticator address

Description
With this command, you configure the IP address of the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator address <index (1-2)> {ipv4 <ucast_addr> |
fqdn-name <FQDN>}
The parameters have the following meaning:
Parameter
index
ipv4
ucast_addr
fqdn-name
FQDN
Result
The RADIUS server is enabled.
Further notes
You display the setting with the
See also
show wlan security ap-radius-authenticator (Access Point) (Page 389)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Index of the RADIUS server
Keyword for an IPv4 address
IPv4 address
Keyword for a domain name
Domain name (Fully Qualified Domain Name)
show wlan security ap-radius-authenticator
Security and authentication
10.2 WLAN
Range of values / note
1...2
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
command.
393