Nat Timeout (Client) - Siemens SIMATIC NET Configuration Manual

9.1.3.6

nat timeout (Client)

Note
This command is only available in the client mode.
Description
With this command, you configure the time period for the TCP / UDP connection. If no data
exchange takes place, the TCP / UDP connection is deleted from the translation table when
this time has elapsed.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
nat {tcp|udp} timeout <seconds>
The parameters have the following meaning:
Parameters
tcp
udp
seconds
Result
The period of time is configured.
Further notes
You show the NAT configuration and the translation list with the
You delete the period of time with the
See also
show nat (Client) (Page 371)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
TCP connection
UDP connection
Period of time in seconds
no nat timeout
Layer 3 functions
Range of values / note
-
-
1 ... 4294967295
command.
show nat
command.
9.1 NAT
379