Commands In The Interface Configuration Mode; Switchport Acceptable-Frame-Type - Siemens SIMATIC NET Configuration Manual

6.2.3

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
6.2.3.1

switchport acceptable-frame-type

Description
With this command, you configure which types of frames the interface accepts.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
The parameters have the following meaning:
Parameters
all
tagged
At system start or when using the
following defaults apply:
● The function is configured for
Result
The setting is enabled.
Further notes
You can display the status of this function and other information with the
config
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
All frames (with and without VLAN variables) are accepted
Only frames with VLAN variables are accepted
command.
command to change to this mode.
interface
exit
end
command with the option
restart
.
all
Network structures
command, you return to the
command, you return to the
or
memory factory
show vlan port
6.2 VLAN
, the
229