Wlan Channel (Access Point) - Siemens SIMATIC NET Configuration Manual

6.1.5.22

wlan channel (Access Point)

Description
With this command, you specify the channel via which the access point communicates with
the client.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan channel { show-channels | <number(0=auto)> }
The parameters have the following meaning:
Parameters
show-channels
number
Result
The channel is set.
Further notes
You display the setting with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Lists the available channels.
Channel number
If you want the access point to
search for a free channel itself, use
"0".
show wlan ap <wlan 0/X>
Network structures
Range of values / note
--
Enter the channel number.
Default setting for both frequency
bands:
0 = Auto
command.
6.1 WLAN
175