No Spanning-Tree Mst Max-Hops - Siemens SIMATIC NET Configuration Manual

Result
The setting for the maximum number of hops is configured.
Further notes
You can reset the setting for the maximum number of nodes to the default with the
spanning-tree mst max-hops
You display this setting and other information with the
configuration
6.3.3.13

no spanning-tree mst max-hops

Description
With this command, you reset the maximum number of hops that a path in an MST can run
through to the default value.
The default value is 20.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree mst max-hops
Result
The setting for the maximum number of nodes is reset to the default value.
Further notes
You can configure the setting for the maximum number of nodes with the
max-hops
You display this setting and other information with the
configuration
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.
command.
command.
Network structures
6.3 Spanning Tree
show spanning tree mst
spanning-tree mst
show spanning tree mst
no
259