Wds Partner Wds-Id (Access Point) - Siemens SIMATIC NET Configuration Manual

6.1.7.3

wds partner wds-id (access point)

Description
With this command, you enter the WDS ID of the WDS partner.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds partner wds-id <wds-id>
The parameter has the following meaning:
Parameters
wds-id
Result
The WDS ID is specified.
Further notes
You display the setting with the
See also
wds partner id-type (access point) (Page 213)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
WDS ID of the WDS partner
show wlan wds <wdsX 0/Y>
Network structures
command.
6.1 WLAN
215